How to put SLAM XCAM into 9008 flashing mode?

shilaitec
Apr 10
1 min read

Press and hold both the Volume Up and Volume Down buttons at the same time, then press the Power button. Keep holding for about 10 seconds, and you will enter the 9008 flashing mode. Then connect the device to your Mac computer.

Recent Posts

See All

How to flash the SLAM XCAM using a Mac?

Announcement on Optimization of Default Preview Resolution Settings for Camera Equipment

Dear SLAMXCAM Users, Greetings! Thank you for your continued support and trust in our products. To further enhance the user experience and address frequently reported issues such as insufficient batte

Introduction to the Two 3D Photo Formats of SLAMXCAM

This tutorial will explain in detail the two 3D photo formats in SLAMXCAM and how to switch between them to meet different usage requirements such as real-time preview, 3D display, and left/right eye

Comments